orders of files for all sd nfusions

[xpac]

1st load boot_g3x_to_r3x_v1.23.bin in boot mode to load the fille once you hit start down then ok turn the switch off and back on from the back of the reciver. When its done it will say NUnu on the front of the reciver.

2nd load 090701_factory_U48.bin in boot mode to load the fille once you hit start down then ok turn the switch off and back on from the back of the reciver. After its loaded it will say good then reboot and the 0000 on the front of the reciver.

3rd load nfusion_boot_v130.bin in boot mode to load the fille once you hit start down then ok turn the switch off and back on from the back of the reciver. when done it sometimes say NUnu and other times good then reboots and the 0000 on the front of the reciver.

4th load 090928_sol_v153_1.bin in main mode to load the fille once you hit start down then ok turn the switch off and back on from the back of the reciver. after its loaded it will say good then reboot and the 0000 on the front of the reciver.

5th load 154-2-(255).bin in main mode to load the fille once you hit start down then ok turn the switch off and back on from the back of the reciver. after its loaded it will say good then reboot and the 0000 on the front of the reciver.

Now goto menu systems setting, SW version and it should say this:

Boot :R3X 1.30 Software Ver : 1.54.2 IPVR 0.77 CRC is Correct